ACCUSTAT^™ BMS^™


Building Management System

• Room Pressure Monitor
• Negative Pressure Room Monitors
• Positive Pressure Room Monitors
• Isolation Room Equipment

There are two remote monitoring possibilities with the ACCUSTAT™: A direct interface with the building management system (ACCUSTAT™ BMS) or a localized remote module (following section). The BMS is a built-in module to allow transmission of a 4-20 mA analog output. This can be tied into a BAS/EMCD system. An alarm contact is also provided by the monitor for visual or audible remote annunciation. The time-delayed audible alarm feature is activated after a one minute time expiration.





ACCESSORIES -
Remote Monitoring Panel

This option allows the status of up to six rooms to be individually monitored from a single monitoring station. The stainless steel panel contains six red and green status LEDs, which conform to the status of the individual stationary ACCUSTAT’s monitoring the rooms. An audible alarm signal with mute feature and bi-color LED for visual references, identify any room in non-compliance. Additional mute switches can be included to disable indications for individual rooms in the event the room isn’t being utilized to monitor negative pressure.

Remote Monitoring Panel - Remotely
monitor up to 6 locations with bi-color
visual and audio alarm features.

(Photo of Room Pressure Monitor)
Picture shows ACCUSTAT™ pressure monitor
positioned outside patient isolation room